ASTM-A34 › Standard Practice for Sampling and Procurement Testing of Magnetic Materials
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes sampling procedures and test practices for determination of various magnetic properties of both soft and hard magnetic materials.
1.2 This practice may be used either in conjunction with, or independent of, the standard test methods and materialsspecifications under the jurisdiction of ASTM Committee A06. In the former situation, the sampling and testingprocedures listed herein shall not supersede those found in the individual test methods and materials specifications. In the latter situation, the sampling and testing procedures listed herein shall strictly apply.
1.3 The values stated in either customary (cgs-emu and inch-pound) units or SI units are to be regarded separately as standard. Within this practice, the SI units are shown in brackets except for the sections concerning calculations where there are separate sections for the respective unit systems. the values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this practice.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
density; electrical steel; magnetic material; magnetic test; ICS Number Code 29.030 (Magnetic materials)
To find similar documents by ASTM Volume:
To find similar documents by classification:
29.030 (Magnetic materials Steels with special magnetic properties, see 77.140.40)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A1008Standard Specification for Steel, Sheet, Cold-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, Solution Hardened, and Bake Hardenable
ASTM-E18
Standard Test Methods for Rockwell Hardness of Metallic Materials
ASTM-A568
Standard Specification for Steel, Sheet, Carbon, Structural, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for
Document Number
ASTM-A0034_A0034M-06R21
Revision Level
2006 R21 EDITION
Status
Current
Modification Type
Revision
Publication Date
Feb. 19, 2021
Document Type
Practice
Page Count
4 pages
Committee Number
A06.01