ASTM-A428 › Historical Revision Information
Standard Test Method for Weight [Mass] of Coating on Aluminum-Coated Iron or Steel Articles
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers procedures for determining the weight [mass] of coating on aluminum-coated iron or steel sheets and wire, and on other aluminum-coated iron and steel articles.
1.2 The final results determined by this test method shall be expressed in inch-pound units or SI units, depending on the units used in the material specification to which the results are to be compared. Certain portions of the procedure involving determination of specimen weight [mass] have traditionally been performed in SI units, and corresponding inch-pound units are not included.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see Note 1.
Keywords
aluminum coating; coating weight [mass]; steel sheets; steel wire; ICS Number Code 25.220.40 (Metallic coatings)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A428/A428M-95
Revision Level
1995 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 10, 1995
Document Type
Test Method
Page Count
4 pages
Committee Number
A05.07