ASTM-A574 › Historical Revision Information
Standard Specification for Alloy Steel Socket-Head Cap Screws

ASTM-A574 - 2004(E1) EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification2 covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws. The screws shall be fabricated from steel which has been made by the open-hearth, basic-oxygen, or electric-furnace process. The screws shall be fabricated from alloy steel made to a fine grain practice. The screws shall be alloy steel conforming to the chemical composition specified. There shall be no evidence of carburization or total decarburization on the surfaces of the heat-treated screws when measured. Hardness, tensile strength, yield strength, and elongation shall be tested to meet the requirements prescribed.

ORDER

Scope

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required.

Note 1—A complete metric companion to Specification A 574 has been developed-A 574M; therefore no metric equivalents are presented in this specification.

1.2 The following hazard caveat pertains only to the test method portion, Section 12, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

alloy steel; cap screws; socket head; ICS Number Code 21.060.10 (Bolts, screws, studs)

To find similar documents by ASTM Volume:

01.08 (Fasteners; Rolling Element Bearings)

To find similar documents by classification:

21.060.10 (Bolts, screws, studs)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-A574-04e1

Revision Level

2004(E1) EDITION

Status

Superseded

Modification Type

Editorially changed

Publication Date

Oct. 1, 2006

Document Type

Specification

Page Count

8 pages

Committee Number

F16.02