ASTM-A687 › Historical Revision Information
Standard Specification for High-Strength Nonheaded Steel Bolts and Studs (Withdrawn 1999)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers the chemical and mechanical requirements for quenched and tempered steel nonheaded bolts and studs with enhanced Charpy V-notch impact properties for anchorage and other purposes. The material shall be alloy steel as described in Table 1 and is limited to 5/8 to 3 in. (15.875 to 76 mm) inclusive, in nominal diameter.
1.2 This specification does not apply to mechanical expansion anchors for concrete or to powder-activated nails or studs for concrete or steel.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
Keywords
Anchorage; Steel bolting materials-bolts; Steel bolting materials-studs; high-strength nonheaded bolts/studs, quenched and tempered with enhanced; Charpy V-notch impact properties for anchorage use, spec; ICS Number Code 21.060.10 (Bolts, screws, studs)
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
21.060.10 (Bolts, screws, studs)
Document Number
ASTM-A687
Revision Level
ADOPT WITHDRAWN
Status
Superseded
Modification Type
Withdrawn
Publication Date
April 18, 2011
Document Type
Specification
Page Count
1 page
Committee Number
F16.02