ASTM-A688 › Historical Revision Information
Standard Specification for Welded Austenitic Stainless Steel Feedwater Heater Tubes
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers welded austenitic stainless steel feedwater heater tubes including those bent, if specified, into the form of U-tubes for application in tubular feed-water heaters.
1.2 The tubing sizes covered shall be 5/8 to 1 in. [15.9 to 25.4 mm] inclusive outside diameter, and average or minimum wall thicknesses of 0.028 in. [0.7 mm] and heavier.
1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
Keywords
austenitic stainless steel; feedwater heater tubes; stainless steel tube; steel tube; welded steel tube; ICS Number Code 23.040.10 (Iron and steel pipes)
To find similar documents by ASTM Volume:
01.01 (Steel--Piping, Tubing, Fittings)
To find similar documents by classification:
23.040.10 (Iron and steel pipes Steel pipes and tubes for specific use, see 77.140.75)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A688/A688M-02
Revision Level
2002 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
July 10, 2002
Document Type
Specification
Page Count
6 pages
Committee Number
A01.10