ASTM-C1029 › Historical Revision Information
Standard Specification for Spray-Applied Rigid Cellular Polyurethane Thermal Insulation
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers the types and physical properties of spray applied rigid cellular polyurethane intended for use as thermal insulation. The operating temperatures of the surfaces to which the insulation is applied shall not be lower than -22°F (-30°C) or greater than +225°F (+107°C). For specific applications, the actual temperature limits shall be as agreed upon between the manufacturer and the purchaser.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
air seal; monolithic; SPF; thermal insulation; ICS Number Code 83.100 (Cellular materials)
To find similar documents by ASTM Volume:
04.06 (Thermal Insulation; Building and Environmental Acoustics)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1029-90
Revision Level
1990 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 27, 1990
Document Type
Specification
Page Count
4 pages
Committee Number
C16.22