ASTM-C1048 › Historical Revision Information
Standard Specification for Heat-Strengthened and Fully Tempered Flat Glass
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers the requirements for flat heat-strengthened and flat fully tempered coated and uncoated glass used in general building construction.
1.2 The dimensional values, except thickness designations, stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
edge compression; heat-strengthened glass; heat-treated glass; surface compression; tempered glass; ICS Number Code 81.040.30 (Glass products)
To find similar documents by ASTM Volume:
15.02 (Glass; Ceramic Whitewares)
To find similar documents by classification:
81.040.30 (Glass products Bottles, pots, jars, see 55.100 Laboratory glassware, see 71.040.20)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1048-87
Revision Level
1987 EDITION
Status
Superseded
Publication Date
Sept. 25, 1987
Document Type
Specification
Page Count
7 pages
Committee Number
C14.08