ASTM-D1119 › Historical Revision Information
Standard Test Method for Percent Ash Content of Engine Coolants
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of ash content after ignition of commercial engine coolants and antirusts, as packaged or after use.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 7.1 and 7.3.
Significance and Use
This test method is designed to aid in identifying types of coolants. While the ash is primarily due to the inorganic inhibitors used, it is not a measure of the total inhibitor concentration because of the loss of organic inhibitors.
An ash content greater than that stated in Specification D 3306
Keywords
ash; engine coolant; ICS Number Code 71.100.45 (Refrigerants and antifreezes)
To find similar documents by ASTM Volume:
To find similar documents by classification:
71.100.45 (Refrigerants and antifreezes)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1119-05
Revision Level
2005 EDITION
Status
Superseded
Modification Type
Revision with Title Change
Publication Date
June 1, 2005
Document Type
Test Method
Page Count
2 pages
Committee Number
D15.04