Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of the equilibrium boiling point of engine coolants. The equilibrium boiling point indicates the temperature at which the sample will start to boil in a cooling system under equilibrium conditions at atmospheric pressure.

Note 1-Engine coolants may also be marketed in a ready-to-use form (prediluted). This test procedure is applicable to diluted solutions as well as to concentrates. Note 2-The procedure for obtaining a representative test sample of a coolant solution that contains an antileak additive, is found in Test Method D1176.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Boiling point; Engine coolants; Equilibrium boiling point; boiling point (equilibrium)-engine coolants, test

To find similar documents by ASTM Volume:

15.05 (Engine Coolants; Halogenated Organic Solvents and Fire Extinguishing Agents; Industrial and Specialty Chemicals)

To find similar documents by classification:

71.100.45 (Refrigerants and antifreezes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.