ASTM-D2578 › Historical Revision Information
Wetting Tension of Polyethylene & Polypropylene Films, Standard Test Method For
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement of the wetting tension of a polyethylene or polypropylene film surface in contact with drops of specific test solutions in the presence of air.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in Section 8.
Keywords
Plastic sheet and film-polyethylene (PE); Polyethylene (PE) sheet and film; Polypropylene (PP); Wetting tension; wetting tension-polyethylene (PE)/polypropylene (PP) films, test; ICS Number Code 83.140.10 (Films and sheets)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.140.10 (Films and sheets Including plates)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2578-94
Revision Level
1994 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
March 15, 1994
Document Type
Test Method
Page Count
3 pages
Committee Number
D20.19