ASTM-D2809 › Historical Revision Information
Standard Test Method for Cavitation Corrosion and Erosion-Corrosion Characteristics of Aluminum Pumps With Engine Coolants
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the evaluation of the cavitation corrosion and erosion-corrosion characteristics of aluminum automotive water pumps with coolants.
Note 1—During the development of this test method, it was found that results obtained when testing two-phase coolants did not correlate with results from field tests. Therefore, the test method cannot be recommended as being a significant test for determining cavitation effects of two-phase coolants.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 5.2.
Keywords
aluminum; automotive; cavitation corrosion; engine coolant; erosion-corrosion; pumps; test; ICS Number Code 23.080 (Pumps)
To find similar documents by ASTM Volume:
To find similar documents by classification:
23.080 (Pumps Pumps for fluid power systems, see 23.100.10 Vacuum pumps, see 23.160)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2809-04e1
Revision Level
2004(E1) EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Aug. 1, 2005
Document Type
Test Method
Page Count
6 pages
Committee Number
D15.09