ASTM-D2911 › Standard Specification for Dimensions and Tolerances for Plastic Bottles
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers the thread configuration and dimensions for finishes for plastic bottles with screw-type closures, having a maximum capacity of 18.9 L (5 gal) and a maximum bottle dimension of 305 mm (12 in.). Included are tolerances for bottle capacity and body dimensions.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 The following precautionary caveat pertains only to the test methods portion, Section 8 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1-There is no similiar or equivalent ISO standard.Keywords
bottles; containers-thermoplastic; dimensions; finish; volume; dimensions/tolerances for plastic bottles (with screw-type closures); ICS Number Code 55.100 (Bottles. Pots. Jars)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
55.100 (Bottles. Pots. Jars Small containers for liquids and their closures)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2911_D2911M-16R23
Revision Level
2016 R23 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Nov. 6, 2023
Document Type
Specification
Page Count
17 pages
Committee Number
D20.20