ASTM-D3065 › Historical Revision Information
Standard Test Methods for Flammability of Aerosol Products
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the determination of flammability hazards for aerosol products.
1.2 These test methods appear in the following order:
Section | |
Flame Projection Test | 4 to 7 |
Closed Drum Test | 8 to 10 |
1.3 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
aerosol packaging; aerosol safety; flammability of aerosol products
To find similar documents by ASTM Volume:
15.10 (Packaging; Flexible Barrier Packaging)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3065-94
Revision Level
1994 EDITION
Status
Superseded
Modification Type
Jurisdiction Change
Publication Date
Nov. 15, 1994
Document Type
Test Method
Page Count
3 pages
Committee Number
D10.33