ASTM-D3483 › Historical Revision Information
Standard Test Methods for Accumulated Deposition in a Steam Generator Tube
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover determination of the weight per unit area of waterside deposits on heat-transfer surfaces of steam generator tubes. Two test methods are given as follows:
Sections Test Method A---Mechanical Removal 6 to 11 Test Method B---Solvent Removal 12 to 181.2 Neither test method is normally applicable to fire-tube boilers.
1.3 A comparison of the results obtainable with the two test methods is shown in Fig. 1.
1.4 A scope section is provided in each test method. It is the responsibility of the analyst to determine the acceptability of these test methods for each situation.
1.5 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
boiler tubes; density; deposits; steam generators; ICS Number Code 27.040 (Gas and steam turbines. Steam engines)
To find similar documents by ASTM Volume:
To find similar documents by classification:
27.040 (Gas and steam turbines. Steam engines Hydraulic turbines, see 27.140)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3483-83
Revision Level
1983 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
April 29, 1983
Document Type
Test Method
Page Count
4 pages
Committee Number
D19.03