ASTM-D3575 › Historical Revision Information
Standard Test Methods for Flexible Cellular Materials Made From Olefin Polymers
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods apply to flexible closed cell materials made from olefin polymers or blends of olefin polymers with other polymers as defined in Section 3.
1.2 These test methods cover test procedures only. Product requirements are outlined in Specification D 4819
1.3 Unless specifically stated otherwise, by agreement between the purchaser and supplier, all tests shall be performed in accordance with the test methods specified in this standard.
1.4 The values stated in SI units are to be regarded as the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability or regulatory limitations prior to use.
Note 1—This standard and ISO 7214 address the same subject matter, but differ in technical content.
Significance and Use
The test procedures provide a standard method of obtaining data for research and development, quality control, acceptance and rejection under specifications, and special purposes.
The data obtained by these test methods are applicable to the material under conditions of the particular test and are not necessarily the same as obtained in other environments or use conditions.
Keywords
closed cell materials; flexible cellular; olefin polymers; Buoyancy; Compression testing--rubber; Creep; Density--rubber; Flexible cellular materials; Foam rubber; Olefin plastics; Tear resistance; Tensile properties/testing--rubber/relatged materials; Thermal stability--plastics; ICS Number Code 83.1000
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3575-08
Revision Level
2008 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Feb. 1, 2008
Document Type
Test Method
Page Count
9 pages
Committee Number
D20.22