ASTM-D3846 › Historical Revision Information
Standard Test Method for In-Plane Shear Strength of Reinforced Plastics
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the in-plane shear strength of reinforced thermosetting plastics in flat sheet form in thicknesses ranging from 2.54 to 6.60 mm (0.100 to 0.260 in.).
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1—This standard has no known ISO equivalent.
Keywords
compressive shear; in-plane shear; plastics; reinforced plastics; ICS Number Code 83.120 (Reinforced plastics)
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.120 (Reinforced plastics Materials for the reinforcement of plastics, see 59.100)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3846-94
Revision Level
1994 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
June 15, 1994
Document Type
Test Method
Page Count
3 pages
Committee Number
D20.18