ASTM-D3950 › Historical Revision Information
Standard Specification for Strapping, Nonmetallic (and Joining Methods)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers nonmetallic strapping and joining methods for closing, reinforcing, and bundling materials for shipment, unitizing, palletizing, and bracing for car and truck loading. The strappings are classified into five types according to the type of materials used. If necessary, seals and buckles made from steel with zinc, black iron oxide, or any equivalent corrosion protective coatings or plastic buckles may be used. Each sample should be collected and tested using the given procedures and should conform to the required values of breaking strength and elongation, transverse strength, and joint strength, when applicable, for each strapping type.
Scope
1.1 This specification covers nonmetallic strapping and joining methods intended for use in closing, reinforcing, and bundling articles for shipment, unitizing, palletizing, and bracing for car loading and truck loading.
1.2 The values stated in inch-pound units are to be regarded as standard.
Keywords
closing; joining methods; nonmetallic strapping; palletizing; reinforcing; strapping; unitizing; ICS Number Code 55.040 (Packaging materials and accessories)
To find similar documents by ASTM Volume:
15.10 (Packaging; Flexible Barrier Packaging)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3950-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 1, 2007
Document Type
Specification
Page Count
7 pages
Committee Number
D10.25