ASTM-D4007 › Historical Revision Information
Standard Test Method for Water and Sediment in Crude Oil by the Centrifuge Method (Laboratory Procedure)
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This test method describes the laboratory determination of water and sediment in crude oils by means of the centrifuge procedure. This centrifuge method for determining water and sediment in crude oils is not entirely satisfactory. The amount of water detected is almost always lower than the actual water content. When a highly accurate value is required, the revised procedures for water by distillation (Test Method D4006 (Note 1)) and sediment by extraction (Test Method D473) must be used.Note 1-Test Method D4006 has been determined to be the preferred and most accurate method for the determination of water.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see 6.1 and 7.
Centrifuge method; water and sediment in crude oil, by centrifuge method,test,; Crude oils; water/sediment content, by centrifuge method (laboratory procedure),; test,; Sediment content; water/sediment content (of crude oil), by centrifuge method, test,; Water content-crude oil; centrifuge method, test,; Water plus sediment content; crude oil, by centrifuge method (laboratory procedure), test
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
1981 R95(E1) EDITION
Sept. 1, 1995