Document Center is acquired by Nimonik

Scope

1.1 This practice covers a calibration technique based on the preparation of standards of known water content. This technique is applicable to the production of standards between 20 and 2000 cm³/m ³ water.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This practice is intended to provide a method to calibrate moisture analyzers used on-stream or in the laboratory.

Keywords

ICS Number Code 75.100 (Lubricants, industrial oils and related products)

To find similar documents by ASTM Volume:

05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)

To find similar documents by classification:

71.040.10 (Chemical laboratories. Laboratory equipment Including hydrometers, alcoholometers, etc. Apparatus for measurement of volume, mass, density, viscosity, see 17.060 Spectroscopes, see 17.180.30 Temperature-measuring instruments, see 17.200.20 Laboratory ware, see 71.040.20)

75.100 (Lubricants, industrial oils and related products Including mineral oils, fluids for metal working and for temporary protection against corrosion Lubrication systems, see 21.260 Insulating oils, see 29.035.40)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.