ASTM-D4178 › Historical Revision Information
Standard Practice for Calibrating Moisture Analyzers
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers a calibration technique based on the preparation of standards of known water content. This technique is applicable to the production of standards between 20 cm3/m3 and 2000 cm3/m3 water.
1.2 The values stated in SI units are to be regarded as standard.
1.2.1 Exception—The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
3.1 This practice is intended to provide a method to calibrate moisture analyzers used on-stream or in the laboratory.
Keywords
calibration; carrier gas; moisture analyzer; water content;
To find similar documents by ASTM Volume:
05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4178-82(2017)
Revision Level
1982 R17 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Nov. 1, 2017
Document Type
Practice
Page Count
3 pages
Committee Number
D02.D0