ASTM-D4385 › Historical Revision Information
Standard Practice for Classifying Visual Defects in Thermosetting Reinforced Plastic Pultruded Products
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers acceptance criteria for visual acceptance of thermosetting reinforced plastic pultruded rods, bars, shapes, and sheets.
1.2 This practice presents definitions of possible defects to serve as a guide for contracts, drawings, product specifications, and final inspection.
1.3 This practice also categorizes different inspection requirements for three grades of product quality.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1—There is no similar or equivalent ISO standard.
Keywords
pultrusion; structural shapes; visua; ICS Number Code 83.120 (Reinforced plastics)
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.120 (Reinforced plastics Materials for the reinforcement of plastics, see 59.100)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4385-95
Revision Level
1995 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
June 15, 1995
Document Type
Practice
Page Count
6 pages
Committee Number
D20.18