Document Center is acquired by Nimonik

Scope

1.1 This test method describes the procedure for measuring that part of the drive weight (hammer) kinetic energy that enters the penetrometer connector rod column during dynamic (hammer impact) penetrometer testing of soil.

1.2 This test method has particular application to the comparative evaluation of hammer systems, and, to a lesser degree of accuracy, hammer-operator systems, that are used for the penetration testing of soils.

1.3 This test method applies to penetrometers driven from above the ground surface. It is not intended for use with down-hole hammers.

1.4 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are provided for information only.

1.5 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Drive weight (hammer) kinetic energy; Drop tests; Dynamic analysis; Energy; Field testing-rock; Kinetic energy; Penetrometer testing; Rope-cathead systems; Soil; Stress-soil/rock; stress wave energy measurement for dynamic penetrometer testing systems,; test

To find similar documents by ASTM Volume:

04.08 (Soil and Rock (I): D420 - D5876)

To find similar documents by classification:

19.060 (Mechanical testing Including testing equipment Mechanical testing of metals, see 77.040.10)

93.020 (Earthworks. Excavations. Foundation construction. Underground works Including geotechnics Earth-moving machinery, see 53.100)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.