ASTM-D4799 › Historical Revision Information
Standard Practice for Accelerated Weathering Test Conditions and Procedures for Bituminous Materials (Fluorescent UV, Water Spray, and Condensation Method)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes test conditions and procedures for fluorescent UV and condensation exposures conducted according to Practices G 151
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This weathering apparatus is used for comparing the weathering characteristics of bituminous materials against a control material for which the outdoor weathering characteristics are known. It is not possible to establish a precise correlation between accelerated and natural weathering because (1) there are geographical climatic variations, local weather variations, and variations in local pollutants, and (2) the relation between accelerated and natural weathering is material dependent. Acceleration factors differ between materials as well as between formulations of the same material. Guide G 141
Note 1—This practice can be used for other than bituminous materials, but the significance and use have not been evaluated.
Keywords
accelerated weathering; bituminous materials; degradation; exposure; fluorescent UV and condensation; light exposure; roofing; ultraviolet; waterproofing; Fluorescent UV-light apparatus; Light exposure; Ultraviolet (UV) analysis; Accelerated aging/testing--building materials; Accelerated weathering; Bituminous roofing materials; Exposure tests--fluorescent-UV apparatus; ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products); 91.100.50 (Binders. Sealing materials); 93.080.20 (Road construction materials)
To find similar documents by ASTM Volume:
04.04 (Roofing and Waterproofing)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
93.080.20 (Road construction materials Including asphalts, road pavements, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4799-08
Revision Level
2008 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Feb. 1, 2008
Document Type
Practice
Page Count
3 pages
Committee Number
D08.02