ASTM-D4807 › Historical Revision Information
Standard Test Method for Sediment in Crude Oil by Membrane Filtration
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of sediment in crude oils by membrane filtration. This test method has been validated for crude oils with sediments up to about 0.15 mass %.
1.2 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The accepted unit of measure for this test method is mass %.
Keywords
Crude oils; Heating tests-petroleum products; Homogenization efficiency of unknown mixers; Mass; Membrane filters (MF); Sediment content; sediment in crude oil, by membrane filtration, test,; Filters/filter procedures-petroleum analysis; sediment in crude oil, bymembrane filtration, test,;
To find similar documents by ASTM Volume:
05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4807-88(1995)e1
Revision Level
1988 R95(E1) EDITION
Status
Superseded
Publication Date
Sept. 1, 1995
Document Type
Test Method
Page Count
4 pages
Committee Number
D02.02