ASTM-D4807 › Historical Revision Information
Standard Test Method for Sediment in Crude Oil by Membrane Filtration
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of sediment in crude oils by membrane filtration. This test method has been validated for crude oils with sediments up to approximately 0.15 mass %.
1.2 The accepted unit of measure for this test method is mass %, but an equation to convert to volume % is provided (see Note 6).
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 6.1 and Annex A1.
Keywords
crude oil; membrane filtration; sediment; ICS Number Code 75.040 (Crude petroleum)
To find similar documents by ASTM Volume:
05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4807-05
Revision Level
2005 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
June 1, 2005
Document Type
Test Method
Page Count
5 pages
Committee Number
D02.02