Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of sediment in crude oils by membrane filtration. This test method has been validated for crude oils with sediments up to approximately 0.15 mass %.

1.2 The accepted unit of measure for this test method is mass %, but an equation to convert to volume % is provided (see Note 6).

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 6.1 and Annex A1.

Significance and Use

A knowledge of the sediment content of crude oil is important both in refinery operations and in crude oil commerce.

Keywords

crude oil; membrane filtration; sediment; Crude petroleum products; Filters/filter procedures--petroleum analysis; Heating tests--petroleum products; Homogenization efficiency of unknown mixers; Mass; Membrane filters (MF); Sediment content; ICS Number Code 75.040 (Crude petroleum)

To find similar documents by ASTM Volume:

05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)

To find similar documents by classification:

75.040 (Crude petroleum)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.