ASTM-D4986 › Historical Revision Information
Horizontal Burning Characteristics of Cellular Polymeric Materials, Standard Test Method F
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes a small-scale apparatus test procedure for comparing the relative rate of burning and the extent and time of burning of cellular polymeric materials.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This test method should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test method may be used as elements of a fire risk assessment which then takes into account all of the factors that are pertinent to an assessment of the fire hazard and of a particular end use.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Note 1.
Keywords
Burning characterist-rubber/cellular materials; Cellular materials; Fire testing-rubber/cellular materials; Heating tests-chemicals/materials; Horizontal burning; Polymers; horizontal burning characterist-cellular polymeric materials, test; ICS Number Code 13.220.40 (Ignitability and burning behaviour of materials and products); 83.100 (Cellular materials)
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
13.220.40 (Ignitability and burning behaviour of materials and products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4986-98
Revision Level
1998 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
July 10, 1998
Document Type
Test Method
Page Count
6 pages
Committee Number
D20.30