ASTM-D5100 › Historical Revision Information
Standard Test Method for Adhesion of Mineral Aggregate to Hot Bitumen
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method determines the adhesion of mineral aggregate when applied over a pour coat of hot bitumen on a roof membrane.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 The quantities of mineral aggregate adhered to the surface of a roof vary with the characteristics and total amount of the aggregate. Mineral aggregate shields bituminous membranes from solar radiation. Unadhered mineral aggregate can be displaced by wind, water, and traffic, exposing the bitumen.
5.2 This test method provides a laboratory means of determining and recording the mass of aggregate that adheres to a bituminous pour coat.
Keywords
adhered mineral aggregate; hot bitumen; roof membrane;; ICS Number Code 91.100.50 (Binders. Sealing materials)
To find similar documents by ASTM Volume:
04.04 (Roofing and Waterproofing)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5100/D5100M-95a(2018)
Revision Level
1995A R18 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 1, 2018
Document Type
Test Method
Page Count
2 pages
Committee Number
D08.03