ASTM-D5919 Historical Revision Information
Standard Practice for Determination of Adsorptive Capacity of Activated Carbon by a Micro-Isotherm Technique for Adsorbates at ppb Concentrations

ASTM-D5919 - 1996 R11 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Determination of Adsorptive Capacity of Activated Carbon by a Micro-Isotherm Technique for Adsorbates at ppb Concentrations
ORDER

Scope

1.1 This practice covers the assessment of activated carbon for the removal of low concentrations of adsorbable constituents from water and wastewater using the bottle point isotherm technique. It can be used to characterize the adsorptive properties of virgin and reactivated activated carbons.

1.2 This practice can be used in systems with constituent concentrations in the low milligrams per litre or micrograms per litre concentration ranges.

1.3 This practice can be used to determine the adsorptive capacity of and Freundlich constants for volatile organic compounds provided the handling procedures described in this practice are followed carefully.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 The following safety caveat applies to the procedure section of this practice: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This practice allows the adsorption capacity at equilibrium of an activated carbon for adsorbable constituents present in water to be determined. The Freundlich K and 1/n constants that can be calculated based upon information collected using this practice can be used to estimate carbon loading capacities and usages rates for the constituent present in a water stream at other concentrations.

Keywords

activated carbon; adsorption; Activated carbon; Adsorbates; Adsorption; Micro-isotherm technique; PPB concentrations; ICS Number Code 13.030.40 (Installations and equipment for waste disposal and treatment); 13.060.30 (Sewage water)

To find similar documents by ASTM Volume:

15.01 (Refractories, Activated Carbon; Advanced Ceramics)

To find similar documents by classification:

13.030.40 (Installations and equipment for waste disposal and treatment Including street cleaning equipment, waste containers, incineration and compaction equipment, equipment for dumping of refuse, landfill sites, etc. Waste collection vehicles, see 43.160 Waste chutes, see 91.140.70 Food waste disposal units, see 97.040.50)

13.060.30 (Sewage water Including sewage water disposal and treatment Liquid wastes, see 13.030.20 Drainage systems, see 91.140.80 Sewage systems, see 93.030)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D5919-96(2011)

Revision Level

1996 R11 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

June 10, 2011

Document Type

Practice

Page Count

6 pages

Committee Number

D28.02