ASTM-D6184 › Historical Revision Information
Standard Test Method for Oil Separation from Lubricating Grease (Conical Sieve Method)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method is used to determine the tendency of lubricating grease to separate oil at an elevated temperature. This test method shall be conducted to a 100°C for 30 h unless other conditions are required by the grease specification.
1.2 This test method is not suitable for greases having a penetration (Test Methods D 217) greater than 340 (softer than NLGI No. 1 grade).
1.3 Values stated in acceptable SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
cone-bleed test; leakage; lubricating grease; oil bleed; oil separation; ICS Number Code 75.100 (Lubricants, industrial oils and related products)
To find similar documents by ASTM Volume:
05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)
05.03 (Petroleum Products and Lubricants (III): D6138 - D6971)
To find similar documents by classification:
To find similar documents by Federal Supply Class Code:
FSC 9150 (Cutting, Lubricating, and Hydraulic)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6184
Revision Level
WITHDRAWN
Status
Superseded
Modification Type
Revision
Publication Date
July 15, 2014
Document Type
Test Method
Committee Number
D02.G0.03