ASTM-D6319 › Historical Revision Information
Standard Specification for Nitrile Examination Gloves for Medical Application
The following bibliographic material is provided to assist you with your purchasing decision:
This specification contains test procedures for evaluating the performance and safety of nitrile rubber gloves for use in conducting medical examinations and diagnostic and therapeutic procedures. The products covered by this specification include nitrile rubber gloves that fit either hand, paired gloves, and gloves by size and packaged sterile or nonsterile or bulk nonsterile. An approved lubricant for absorbable dusting powder may be applied to the gloves. Other lubricants may also be used, provided, that their safety and efficacy have been previously established. Both the inside and outside surface of the glove should be free of talc. All products should meet the required degree of sterility, freedom from holes, physical requirements before and after ageing, amount of powder on the glove, tensile strength and ultimate elongation.
Scope
1.1 This specification covers certain requirements for nitrile rubber gloves used in conducting medical examinations and diagnostic and therapeutic procedures.
1.2 This specification covers nitrile rubber examination gloves that fit either hand, paired gloves, and gloves by size. It also provides for packaged sterile or nonsterile or bulk nonsterile nitrile rubber examination gloves.
1.3 This specification is similar to that of Specification D3578 for rubber examination gloves.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
Significance and Use
IRMs are vitally important in product and specification testing, in research and development work, in technical service work, and in quality control operations in the rubber and carbon black industries. They are especially valuable for referee purposes. Many ASTM rubber standards for the evaluation of natural or synthetic rubber require the use of specific IRMs in their test recipes for better laboratory repeatability and reproducibility.
New material lots that have been selected as candidates for IRM approval shall conform to the appropriate specifications given in this standard and meet requirements given in Practice D4678 before the lots may be accepted as IRMs.
The chemical and physical IRM specifications shown will ensure some consistency in IRM properties from one lot to the next. However, the specifications cannot ensure exact inter-lot consistency.
Keywords
examination gloves; nitrile; rubber; Medical examination gloves--specifications; Nitrile rubber; Rubber medical/surgical applications--specifications; ICS Number Code 11.140 (Hospital equipment)
To find similar documents by ASTM Volume:
09.02 (Rubber Products, Industrial - Specifications and Related Test Methods; Gaskets; Tires)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6319-10
Revision Level
2010 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 1, 2010
Document Type
Specification
Page Count
4 pages
Committee Number
D11.40