Document Center is acquired by Nimonik

Scope

1.1 This guide describes quality assurance (QA) protocols for the determination of the anions and cations in Atmospheric Wet Deposition (AWD) shown in Table 1.

1.2 Included in this guide are minimum recommended requirements for the preparation of calibration standards and suggested procedures for validating laboratory measurement results.

1.3 This guide describes minimum requirements for the frequency of analysis of quality assurance samples and recommends procedures for the evaluation of quality assurance data.

1.4 The guide's recommendations are based upon expected anion and cation concentrations in AWD (1) and Appendix X2.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

atmospheric deposition; atomic absorption spectrophotometry; ion chromatography; quality assurance; quality control; wet deposition; ICS Number Code 03.120.10 (Quality management and quality assurance); 13.040.20 (Ambient atmospheres); 71.040.40 (Chemical analysis)

To find similar documents by ASTM Volume:

11.07 (Atmospheric Analysis)

To find similar documents by classification:

03.120.10 (Quality management and quality assurance)

13.040.20 (Ambient atmospheres Including indoor air)

71.040.40 (Chemical analysis Including analysis of gases and surface chemical analysis)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.