ASTM-D6335 › Historical Revision Information
Standard Test Method for Determination of High Temperature Deposits by Thermo-Oxidation Engine Oil Simulation Test
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the procedure to determine the amount of deposits formed by automotive engine oils utilizing the thermo-oxidation engine oil simulation test (TEOST). An interlaboratory study has determined it to be applicable over the range from 10 to 65 mg total deposits.
Note 1—Operational experience with the test method has shown the test method to be applicable to engine oils having deposits over the range from 2 to 180 mg total deposits.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
deposits; engine oil; oxidation; pyrolysis; TEOST; thermal decomposition; thermal oxidation
To find similar documents by ASTM Volume:
05.03 (Petroleum Products and Lubricants (III): D6138 - D6971)
05.04 (Petroleum Products and Lubricants (IV): D6973 - latest)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6335-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Jan. 10, 2003
Document Type
Test Method
Page Count
8 pages
Committee Number
D02.09.0G