Document Center is acquired by Nimonik

Scope

1.1 This guide covers sampling of carbon cathode blocks used in the production of aluminum, and details procedures for taking test samples from single cathode blocks. It covers equipment and procedures for obtaining samples from cathode blocks in a manner that does not destroy the block or prevent its subsequent use as originally intended. However, the user must determine the subsequent use of the sampled cathode blocks. Preferred locations for taking samples from single units of cathodes are covered in this guide.

1.1.1 Information for sampling of shaped refractory products, in general, is given in ISO 5022. This standard details the statistical basis for sampling plans for acceptance testing of a consignment or lot. Cathode blocks used in the production of aluminum have specific requirements of sampling, and while the statistical basis for sampling given in ISO 5022 applies, further or modified requirements may also apply.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—The following ASTM standards are noted as sources of useful information: Test Methods C 559, C 611, C 651, C 747, C 1025, C 1039, and C 1225.

Significance and Use

Core sampling is an acceptable way of obtaining a test specimen without destroying the usefulness of a cathode block.

Test specimens obtained by this guide can be used by producers and users of cathode blocks for the purpose of conducting the tests in Note 1 to obtain comparative physical properties.

Sampling shall not weaken the cathode or increase the likelihood of premature failure. Extreme care shall be exercised when taking vertically drilled samples.

Keywords

anthracite; carbon; cathodes; core; graphite; sample; sampling; test specimens; Aluminum; Aluminum industry; Anthracite; Carbon cathode blocks; Cathode carbon; Core sampling; Graphite; Sampling metals/alloys; ICS Number Code 77.020 (Production of metals)

To find similar documents by ASTM Volume:

05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)

05.03 (Petroleum Products and Lubricants (III): D6138 - D6971)

To find similar documents by classification:

77.020 (Production of metals)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.