ASTM-D6484 › Standard Test Method for Open-Hole Compressive Strength of Polymer Matrix Composite Laminates
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method determines the open-hole compressive strength of multidirectional polymer matrix composite laminates reinforced by high-modulus fibers. The composite material forms are limited to continuous-fiber or discontinuous-fiber (tape or fabric, or both) reinforced composites in which the laminate is balanced and symmetric with respect to the test direction. The range of acceptable test laminates and thicknesses are described in 8.2.1.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
Keywords
composite materials; compression testing; open-hole compressive strength; ICS Number Code 83.120 (Reinforced plastics)
To find similar documents by ASTM Volume:
15.03 (Space Simulation; Aerospace and Aircraft; Composite Materials)
To find similar documents by classification:
83.120 (Reinforced plastics Materials for the reinforcement of plastics, see 59.100)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
IPC-A-610Acceptability of Electronic Assemblies (Hardcopy format)
IPC-A-600
Acceptability of Printed Boards
IPC-2221
Generic Standard on Printed Board Design
Document Number
ASTM-D6484_D6484M-23
Revision Level
2023 EDITION
Status
Current
Modification Type
Editorially changed
Publication Date
Oct. 6, 2023
Document Type
Test Method
Page Count
19 pages
Committee Number
D30.05