ASTM-D6535 › Historical Revision Information
Determining the Dip Tube Length of a Mechanical Pump Dispenser, Standard Test Method For
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination technique for a dip tube of a mechanical pump dispenser.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method is to be used to determine the length of a dip tube of a mechanical pump dispenser that extends to the bottom-corner of a container.
This test method is to be used to determine the length of a dip tube of a mechanical pump dispenser that extends to the bottom-center of a container.
Keywords
dip tube determination; dispenser; mechanical pump dispenser; Dip tube applications; Dispensers; Mechanical pump dispensers; ICS Number Code 55.130 (Aerosol containers)
To find similar documents by ASTM Volume:
15.10 (Packaging; Flexible Barrier Packaging)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6535/D6535M-05(2010)e1
Revision Level
2005 R10(E1) EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
Dec. 1, 2010
Document Type
Test Method
Page Count
3 pages
Committee Number
F02.30