ASTM-D6536 › Historical Revision Information
Measuring the Dip Tube Length of a Mechanical Pump Dispenser, Standard Test Method For
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement technique for a dip tube of a mechanical pump dispenser.
1.2 The values stated in both inch-pound and SI units are to be regarded separately as the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method is to be used to measure the length of a specified dip tube from the bottom of the sealing surface to the end of the dip tube in a mechanical pump dispenser.
This test method is to be used to measure the exposed length of a specified dip tube of a mechanical pump dispenser.
Keywords
dip tube length; dip tube measurement; mechanical pump dispenser; ICS Number Code 55.130 (Aerosol containers)
To find similar documents by ASTM Volume:
15.10 (Packaging; Flexible Barrier Packaging)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6536-00(2005)
Revision Level
2000 R05 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Oct. 1, 2005
Document Type
Test Method
Page Count
2 pages
Committee Number
D10.33