Document Center is acquired by Nimonik

Scope

1.1 This test method covers the measurement technique for a dip tube of a mechanical pump dispenser.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method is to be used to measure the length of a specified dip tube from the bottom of the sealing surface to the end of the dip tube in a mechanical pump dispenser.

This test method is to be used to measure the exposed length of a specified dip tube of a mechanical pump dispenser.

Keywords

dip tube length; dip tube measurement; mechanical pump dispenser; Mechanical pump dispensers; Overall dip tube length; Dip tube applications; ICS Number Code 55.130 (Aerosol containers)

To find similar documents by ASTM Volume:

15.10 (Packaging; Flexible Barrier Packaging)

To find similar documents by classification:

55.130 (Aerosol containers)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.