ASTM-D6895 › Historical Revision Information
Standard Test Method for Rotational Viscosity of Heavy Duty Diesel Drain Oils at 100 degrees C
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the rotational viscosity and the shear thinning properties of heavy duty diesel engine drain oils at 100C, in the shear rate range of approximately 10 to 300 s-1, in the shear stress range of approximately 0.1 to 10 Pa and the viscosity range of approximately 12 to 35 mPas. Rotational viscosity values can be compared at a shear rate of 100 s-1 by this test method.,
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
Rotational viscosity measurements allow the determination of the non-Newtonian, shear thinning property of drain oil. Rotational viscosity values can be compared at a shear rate of 100 s-1 by this test method.2 ,3
Keywords
drain oils; heavy duty diesel; rotational viscosities; shear thinning; ICS Number Code 75.080 (Petroleum products in general)
To find similar documents by ASTM Volume:
05.03 (Petroleum Products and Lubricants (III): D6138 - D6971)
To find similar documents by classification:
75.080 (Petroleum products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6895-06
Revision Level
2006 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 1, 2006
Document Type
Test Method
Page Count
5 pages
Committee Number
D02.07