ASTM-F1249 › Historical Revision Information
Standard Test Method for Water Vapor Transmission Rate Through Plastic Film and Sheeting Using a Modulated Infrared Sensor
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This test method covers a procedure for determining the rate of water vapor transmission through flexible barrier materials. The method is applicable to sheets and films up to 3 mm (0.1 in.) in thickness, consisting of single or multilayer synthetic or natural polymers and foils, including coated materials. It provides for the determination of (1 ) water vapor transmission rate (WVTR), (2) the permeance of the film to water vapor, and (3) for homogeneous materials, water vapor permeability coefficient.
Note 1—Values for water vapor permeance and water vapor permeability must be used with caution. The inverse relationship of WVTR to thickness and the direct relationship of WVTR to the partial pressure differential of water vapor may not always apply.
1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
diffusion cell apparatus; flexible barrier materials; infrared (IR) analysis; plastic sheet and film; polymers; referee methods; water vapor transmission (WVT)-permeability; water vapor transmission rate through plastic film/sheeting (up to 3 mm; (0.1 in.)), using modulated infrared sensor; ICS Number Code 83.140.10 (Films and sheets)
To find similar documents by ASTM Volume:
15.10 (Packaging; Flexible Barrier Packaging)
To find similar documents by classification:
83.140.10 (Films and sheets Including plates)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Oct. 1, 2005