ASTM-F1683 › Historical Revision Information
Standard Practice for Creasing or Bending a Membrane Switch, Membrane Switch Flex Tail Assembly or Membrane Switch Component (Withdrawn 2018)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice establishes a method for the creasing or bending of any part of a membrane switch.
1.2 This practice can be used with other test methods to achieve specific test results.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
bend; crease; membrane switch; tail assembly; ICS Number Code 19.060 (Mechanical testing); 29.120.40 (Switches)
To find similar documents by ASTM Volume:
10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)
To find similar documents by classification:
19.060 (Mechanical testing Including testing equipment Mechanical testing of metals, see 77.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1683
Revision Level
WITHDRAWN
Status
Cancelled
Modification Type
Revision
Publication Date
July 1, 2018
Document Type
Practice
Committee Number
F01.18