ASTM-F2015 › Historical Revision Information
Standard Specification for Lap Joint Flange Pipe End Applications
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the material and dimensional requirements applicable to lap joint flange pipe ends that are manufactured by a mechanical forming process, and are widely used for low-pressure systems in the marine, process piping, and similar industries. Materials having acceptable forming qualities to produce lap joint ends are copper, copper-nickel, titanium, carbon steel, and stainless steel. The lap joint flange pipe connections shall be produced in accordance with accepted shop practices, and shall be free from burrs and cracks that would affect their suitability for intended service.
Scope
1.1 This specification covers the pipe material and wall thickness applicable to lap joint flange pipe ends, manufactured by a mechanical forming process.
1.2 The lap joint flange connection has been widely used for low-pressure systems in the marine, process piping, and similar industries.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
Keywords
lap joint flange; loose flange joint; slip flange joint; spin flange joint; Van Stone flange; ICS Number Code 23.040.60 (Flanges, couplings and joints)
To find similar documents by ASTM Volume:
01.07 (Ships and Marine Technology)
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
23.040.60 (Flanges, couplings and joints)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F2015-00(2013)
Revision Level
2000 R13 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
June 1, 2013
Document Type
Specification
Page Count
5 pages
Committee Number
F25.11