ASTM-F2163 › Historical Revision Information
Standard Specification for Ring, Bearing, Inner: for Needle Roller Bearing With Drawn Outer Ring
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers inner rings for needle roller bearings with drawn outer rings.
1.2 The inner rings specified in this specification are intended for use on unhardened shafts in conjunction with open end needle roller bearings shown on Specification F 2162 and MS52141.
1.3 The use of recycled materials that meet the requirements of the applicable material specification without jeopardizing the intended use of the item is encouraged.
1.4 The inner rings specified in this specification are not intended for use in flight-critical systems of aircraft.
1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.
Note 1—This specification was originally developed by the Department of Defense and maintained by the Defense Supply Center Richmond. It is intended to replicate the requirements of MS 17130.
Keywords
drawn outer ring; inner ring; MS 17130 ; needle roller bearing; ICS Number Code 21.100.20 (Rolling bearings)
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F2163-01e1
Revision Level
2001(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
June 1, 2002
Document Type
Specification
Page Count
3 pages
Committee Number
F34.04