ASTM-F2246 › Historical Revision Information
Standard Specification for Bearing, Roller, Needle: Thick Outer Ring With Rollers and Cage
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers needle roller bearings having thick outer rings, with rollers and cages.
1.2 The bearings being specified are intended to be used with hardened shafts (HRC58-65; see Test Methods E18). For use with unhardened shafts, bearings should be used in conjunction with inner bearing ring MS51962 as specified in Specification F2431 and shown as MS500072 bearing assemblies in Specification F2430.
1.3 The use of recycled materials that meet the requirements of the applicable material specification without jeopardizing the intended use of the item is encouraged.
1.4 Bearings designed to this specification are intended for use in applications requiring high radial load with minimal angular shaft misalignment.
1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Keywords
cage; MS51961; needle roller; oil groove; oil hole; outer ring; radial; RBEC 1; roller bearing
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F2246-06(2013)
Revision Level
2006 R13 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
June 1, 2013
Document Type
Specification
Page Count
4 pages
Committee Number
F34.04