ASTM-F2403 › Standard Specification for Inch Series Machine Screws, Carbon Steel, 60 000 psi Tensile Strength (Withdrawn 2016)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the requirements for non-heat treated carbon steel machine screws. Steel for the machine screws shall be made by open-hearth, basic-oxygen, or electric-furnace process and the screws shall be manufactured by cold forming, thread rolling, and stress-relieve annealing. Heat and product analysis shall be performed to determine the chemical composition of the specimen conforming to the requirements for carbon, phosphorus, and sulfur. Specimens shall be subjected to mechanical tests to verify conformance to the mechanical property requirements such as tensile strength, Rockwell hardness, and ductility.
Scope
1.1 This specification covers the requirements for non-heat treated carbon steel machine screws with nominal diameters of No. 0000 through ¾ in. having a minimum ultimate tensile strength of 60 000 psi.
1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
Keywords
carbon steel; machine screws, Carbon steel; Inch series; Machine screws; Tensile strength; ICS Number Code 21.060.10 (Bolts, screws, studs)
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
21.060.10 (Bolts, screws, studs)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F2403-09
Revision Level
2009 EDITION
Status
Superseded
Modification Type
Withdrawn
Publication Date
May 1, 2009
Document Type
Specification
Page Count
4 pages
Committee Number
F16.02