ASTM-F392 › Historical Revision Information
Standard Test Method for Flex Durability of Flexible Barrier Materials
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the flex resistance of flexible barrier materials. Pinhole formation is the criterion presented for measuring failure, but other tests such as gas-transmission rates can be used in place of the pinhole test.
This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method is valuable in determining the resistance of flexible-packaging materials to flex-formed pinhole failures.
This test method does not measure any abrasion component relating to flex failure.
Physical holes completely through the structure are the only failures measured by the colored-turpentine-pinhole portion of this test. Failures in the integrity of one of the plies of a multi-ply structure will not be determined by the colored-turpentine test. Gas permeation or moisture vapor transmission tests, or both, can be used in conjunction with the flex test to measure the loss of ply integrity. However, any permeation test requiring a pressure differential will not measure the permeation coefficient in the presence of pinholes.
4.3.1 The various conditions described in this procedure are to prevent testing a structure under conditions that either give too many holes to effectively count and be significant (normally greater than 50), or too few to be significant (normally less than five per sample).
Measurements on nylon film, possibly because of its hydrophilic nature, have not shown good reproducibility (between laboratories), although the repeatability of the data within a laboratory was good.
Keywords
barrier; barrier materials; flex crack; flex resistance; flexible; pinhole; ICS Number Code 55.040 (Packaging materials and accessories)
To find similar documents by ASTM Volume:
15.10 (Packaging; Flexible Barrier Packaging)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F392-93(2004)
Revision Level
1993 R04 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 15, 2004
Document Type
Test Method
Page Count
4 pages
Committee Number
F02.50