ASTM-F680 › Historical Revision Information
Standard Test Methods for Nails
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover procedures for the testing of nails. The test or tests selected, and the requirements for compliance, will be as specified in the applicable product standard. Performance tests for nail withdrawal and lateral load capability are not included as they are covered by Test Methods D1761.
1.2 The tests described are as follows:
Section Dimensional tests 5 Tension test 6 Conventional bend test 7 Impact bend test 8 Rockwell hardness test 9 Coating weight test 10 Coating adherence test for zinc-coated nails 111.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are provided for information purposes only.
Keywords
Bend testing; Coating adhesion; Coating thickness; Hardness tests; Hardness tests-Rockwell; Rockwell hardness; nails, test,; Nails; methods of testing
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F680-80(1993)
Revision Level
1980 R93 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Sept. 26, 1993
Document Type
Test Method
Page Count
3 pages
Committee Number
F16.05