ASTM-F912 › Historical Revision Information
Standard Specification for Alloy Steel Socket Set Screws
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers the requirements for quenched and tempered alloy steel socket-set screws (SSS) 0.060 through 2.000-in. sizes having hardnesses 45 to 53 HRC.
1.2 The hazard statement pertains only to the test method section, Section 11 of this specification. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note1-A complete metric companion to Specification F 912 has been developed-F912M; therefore, no metric equivalents are shown in this Specification.
Keywords
Screws; Steel bolting materials-screws;socket set screws-alloy steel, spec., (for metric see F 912M); ICS Number Code 21.060.10 (Bolts, screws, studs)
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
21.060.10 (Bolts, screws, studs)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F912-90
Revision Level
1990 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Feb. 23, 1990
Document Type
Specification
Page Count
4 pages
Committee Number
F16.02