ASTM-D5190 Historical Revision Information
Standard Test Method for Vapor Pressure of Petroleum Products (Automatic Method) (Withdrawn 2012)

ASTM-D5190 - 1991 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Vapor Pressure of Petroleum Products (Automatic Method) (Withdrawn 2012)
ORDER

Scope

1.1 This test method covers the determination of the total pressure of air-containing, volatile, petroleum products. This test method is suitable for testing samples with boiling points above 0oC (32oF) that exert a vapor pressure between 7 and 172 kPa (1 and 25 psi) at 37.8oC (100oF) at a vapor-to-liquid ratio of 4:1. This test method is suitable for testing gasoline samples that contain oxygenates. No account is made of dissolved water in the sample.

1.1.1 Some gasoline-oxygenate blends may show a haze when cooled to 0 to 1oC. If a haze is observed in , it shall be indicated in the reporting of results. The precision and bias statements for hazy samples have not been determined (see Note 8).

1.2 This test method is suitable for the calculation of a dry vapor pressure equivalent (DVPE) by means of a correlation equation (see ). The calculated DVPE very closely approximates the dry vapor pressure that would be obtained on the same material when tested in accordance with Test Method D4953.

1.3 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are provided for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 7.3 through 7.5 and 9.2.

Keywords

automated vapor pressure measurement; dry vapor pressure; gasoline; hydrocarbon-oxygenate blends; petroleum products; vapor pressure; ICS Number Code 75.080 (Petroleum products in general)

To find similar documents by ASTM Volume:

05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)

05.03 (Petroleum Products and Lubricants (III): D6138 - D6971)

To find similar documents by classification:

75.080 (Petroleum products in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D5190-91

Revision Level

1991 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Nov. 18, 1991

Document Type

Test Method

Page Count

5 pages

Committee Number

D02.08