Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of the density or relative density of engine coolant concentrates and aqueous engine coolants.

1.2 This test method should not be applied to samples so dark in color that the absence of air bubbles in the sample cell cannot be established with certainty.

1.3 The accepted units of measure for density are grams per millilitre or kilograms per cubic metre.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Note 1.

Keywords

aqueous engine coolants; density; digital density analyzer; engine coolant concentrates; relative density

To find similar documents by ASTM Volume:

15.05 (Engine Coolants; Halogenated Organic Solvents and Fire Extinguishing Agents; Industrial and Specialty Chemicals)

To find similar documents by classification:

17.060 (Measurement of volume, mass, density, viscosity Including measuring instruments Volumetric measurements of petroleum products and natural gas, see 75.180.30)

47.020.20 (Marine engines and propulsion systems Standards for internal combustion engines for general use, see 27.020)

71.100.45 (Refrigerants and antifreezes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.